Pneumatic tool (with reverse mode) designed for pipe ramming and drilling.
Ramming of Ø273mm steel pipe directly
Ramming of Ø273mm, Ø324mm, Ø406mm, Ø508mm, Ø610mm, Ø711mm, Ø813mm, Ø1016mm steel pipes with the use of cones
HP260 is an effective pneumatic hammer designed for steel pipes ramming up to Ø800mm in diameter.
This device can be used for steel pipes ramming Ø900mm or Ø1000mm on short distances. The controller and piston of the device were modified. Air consumption was reduced to 8,0 m3/min.
Reverse mode is switched on by turning air supply hose (8-10 turns left).
HP260 ramming tool is recommended for the approximate range of works: Steel pipes ramming in the range of Ø324mm-800mm.