HP240ET (HP240LT).jpg


Pneumatic device (with reverse mode) designed for steel pipes ramming.


Very low air consumption considering the size of the hammer

High efficiency of pipe ramming

Power maintain over the course of few years

Air consumption doesn't increase with time


The HP240ET/HP240LT is a stroke device with high effectiveness of operation, designed for large diameter steel pipes ramming.

HP240LT was introduced in 2014. It was created as a result of the modification of HP240T hammer (introduced in 2006). In the corpse extended by 200mm, a heavier piston was placed. That modification positively influenced the power of the device. The new design utilizes technological specifications of sealing rings well tested in the HP240T model. Thanks to that hammer achieved lower air consumption that doesn't rise within 1-2 years of usage. Maintaining tightness help sustain the constant power of the device. On top of that customers experience a lower cost of fuel used to run compressors and overall usage cost. Reverse mode is turned-on by turning air supply hose (8-10 turns left). Reverse gear is convenient and helps with detaching the hammer from a rammed pipe.

HP240ET/HP240LT is a great supplement for the HP160 in all utility installations. HP240ET/HP240LT is recommended for the approximate range of works: ramming of Ø324mm-610mm steel pipes with a high percentage of 324, 406 & 508mm diameters. The successor to the HP240LT model is the HP240ET hammer.